COMPRESSED AIR VACUUM
FORMING MACHINE

COMPRESSED AIR VACUUM FORMING MACHINEKB-10-50T

COMPRESSED AIR
VACUUM FORMING MACHINE

A Forming Machine That Uses a New Method Researched and Developed Through the Application of Our Long-term.
KAZUM Co., Ltd. performs all machining, assembly, and testing/adjusting in-house to maintain consistency.

FEATURES

  1. POINT1 Energy-saving design thanks to the heat-retaining structure in its heating section Between 3% and 5% less power consumed than those of our competitors.

  2. POINT2 Servo motor (link drive system)

  3. POINT3 Low-temperature forming thanks to the high level of mold clamping force

  4. POINT4 Optimized heater arrangement to quickly heat sheets to a uniform temperature

  5. POINT5 Fire prevention thanks to upward and downward escape of the heater

  6. POINT6 4-stage system for adjusting sheet width

SPECIFICATIONS

Max. Mold Clamping Force 500kN(約50tf)
Forming Area Width 1000 mm × Feed 1150 mm
(max. product depth 150 mm)
Max. Speed Dry cycle 2.0 sec
Work Table Max. Stroke Upper table 170 mm
Lower table 240 mm
Work Table Shut
Height
Upper table 95 mm
Lower table 80 mm
Sheet Feed Chin Clip-chain system
Sheet Heating
System
Elstein heater (2 shots, individual output control; lower heater is quick type)
Option: A medium wavelength heater can also be used

AUTO TRIMMER

AUTO TRIMMERKT-10-7T

AUTO TRIMMER

Research and Development From the Culmination of Our Long-term Experiences With and Knowledge Obtained.
KAZUM Co., Ltd. performs all machining, assembly, and testing/adjusting in-house to maintain consistency.

FEATURES

  1. POINT1 Top-driven system

  2. POINT2 One-touch mold installation

  3. POINT3 Ample safety functions

  4. POINT4 Elevating devices that are used in the input-side sheet guide and pinch roll, being synchronized with the uplift timing

SPECIFICATIONS

Max. Pulling Force 70 kN (roughly 7 tf)
Bed Hole Surface Area Width 320 mm × Length 1080 mm
Max. Speed Regular use max. 100 spm (upper limit 120 spm)
Slide Stroke 200mm
Slide Shut Height(From Lower Section Frame’s Upper Surface) 210–285 mm
(adjustable by up to 75 mm)
Sheet Feed Pinch Roll Input-/Output-side double pinch roll

page topPAGE TOP